TPS adjustment?

[nlped]

I did a search and couldn't find an answer so I thought I would just ask. I have Code 22 which is a TPS low voltage code. I just checked the TPS and sure enough it has 0.35 closed and 3.40 at WOT. I know this is low, but can the TPS be adjusted or do I have to replace it? I know on my mustang and on some Honda's the tps can be adjust some. Could I be lucky enough to have this benefit?

[clinebarger]

no adjustment or not much heres a chart. the wot voltage is way low should be about 4.50vdc

[clinebarger]

heres some more i found


Notes Voltage
Note: The Throttle Position is not adjustable on this engine.
At Idle Or Closed Throttle Normal 0.45 to 0.95 V
Maximum 1.25 V
Wide Open Throttle 4.0 to 4.5 V

[clinebarger]

I was thinking about your readings maybe somone adjusted the throttle blades to make up for a vacuum leak so it whould idle down?

[83burban]

The TPS can be adjusted.

First - Locate the adjusting screw...look at the carb from the drivers side just behind the plunger pivot (there is a little D shaped screw there - might be covered by a plug.

If it is covered drill a tiny hole into tho cover (go slow so you don't drill into the adjusting screw) and then screw a sheet-metal screw in there. Pull the plug out.

To adjust...locate the electrical connector (the 3 wire one) and splice a line into the bottom 2 wires. I used 2 of those blue connectors with some wire extensions and 2 butt plugs on the end. I didn't have time to look for the correct tool to adjust so I took a roll pin the was just slightly smaller than the screw and pinched the end into a D shape. I then tapped it onto the adjusting screw lightly and adjusted mine that way.

Leave the TPS connector in and turn the ignition to the on position, but don't turn the car on. Insert your ground wire from the voltmeter into the middle wire and the postive into the bottom wire. Turn the adjusting screw until you get .49 volts at idle. Then advance the throttle slowly checking for even movement of the voltmeter uo to WOT which should be above 4.0 volts.

If the voltage suddenly changes at drops and any point while advancing the throttle its time for a new TPS sensor.

I hope that I described everything well, but it always plays better in your head than when your trying to explain it.

[clinebarger]

Originally Posted by 83burban

The TPS can be adjusted.

First - Locate the adjusting screw...look at the carb from the drivers side just behind the plunger pivot (there is a little D shaped screw there - might be covered by a plug.

If it is covered drill a tiny hole into tho cover (go slow so you don't drill into the adjusting screw) and then screw a sheet-metal screw in there. Pull the plug out.

To adjust...locate the electrical connector (the 3 wire one) and splice a line into the bottom 2 wires. I used 2 of those blue connectors with some wire extensions and 2 butt plugs on the end. I didn't have time to look for the correct tool to adjust so I took a roll pin the was just slightly smaller than the screw and pinched the end into a D shape. I then tapped it onto the adjusting screw lightly and adjusted mine that way.

Leave the TPS connector in and turn the ignition to the on position, but don't turn the car on. Insert your ground wire from the voltmeter into the middle wire and the postive into the bottom wire. Turn the adjusting screw until you get .49 volts at idle. Then advance the throttle slowly checking for even movement of the voltmeter uo to WOT which should be above 4.0 volts.

If the voltage suddenly changes at drops and any point while advancing the throttle its time for a new TPS sensor.

I hope that I described everything well, but it always plays better in your head than when your trying to explain it.

i dont think its a carb. TBI tps can only be adjusted so much. i didnt know anybody ran feedback quadrajets anymore

[nlped]

Thanks guys! I will be purchasing a new TPS this afternoon and installing it.

[nlped]

Well after $36.41 and about 20 minutes, ole Bob is free of that check engine light.

Before the TPS @ idle was .38V. After it is .59V

Before the TPS @ WOT was 3.4V. After it is 4.27!!!

Thanks Clinebarger & others who offered their assistance!

E