The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 08-25-2009, 01:48 PM   #1
chuckthetruck
Registered User
 
chuckthetruck's Avatar
 
Join Date: Jul 2009
Location: Moberly MO
Posts: 59
Tank 2 problems

Just a simple question about my 87 Sierra 1500 i just got home...i filled up the 2nd tank (which has not been used in at least 5 years) for the trip home but could never get the truck to start with the selector on that tank. Any suggestions would went wrong...is there a 2nd fuel pump? Any help is appreciated.
chuckthetruck is offline   Reply With Quote
Old 08-25-2009, 03:03 PM   #2
72 CustomCamper
huh ???
 
72 CustomCamper's Avatar
 
Join Date: Nov 2002
Location: Fredericksburg,Va.
Posts: 3,368
Re: Tank 2 problems

Fuel injected would have pumps in both tanks. It could also be cloged in the switching valve for that tank...


Chuck
__________________
90 Blazer Silverado 350w/ 700R4 and 32" Kelly's

"I am a bomb technician. If you see me running try to keep up!"
72 CustomCamper is offline   Reply With Quote
Old 08-25-2009, 03:07 PM   #3
chuckthetruck
Registered User
 
chuckthetruck's Avatar
 
Join Date: Jul 2009
Location: Moberly MO
Posts: 59
Re: Tank 2 problems

Quote:
Originally Posted by 72 CustomCamper View Post
Fuel injected would have pumps in both tanks. It could also be cloged in the switching valve for that tank...


Chuck
Pretty easy fix...other then i have to drop the FULL tank..maybe syphen (spelling) the gas out into the other tank..
chuckthetruck is offline   Reply With Quote
Old 08-27-2009, 05:05 AM   #4
hatzie
Moderator
 
hatzie's Avatar
 
Join Date: Oct 2008
Location: Wentworth, NH
Posts: 4,977
Re: Tank 2 problems

Unbolt, lift and, slide the bed back about 1ft onto some 4x4 timbers. 2 guys can do it. You can see the sender in the gap between the cab and bed you just can't reach it without moving the bed. Much easier than pulling a full tank.

Quote:
Originally Posted by chuckthetruck View Post
Pretty easy fix...other then i have to drop the FULL tank..maybe syphen (spelling) the gas out into the other tank..
hatzie is offline   Reply With Quote
Old 08-25-2009, 04:05 PM   #5
old Rusty C10
Robert Olson Transport
 
old Rusty C10's Avatar
 
Join Date: Oct 2002
Location: recent transplant to NC USA
Posts: 20,310
Re: Tank 2 problems

first thing you want to do is make sure the switch in the dash to switch tanks has power to both locations after that check to see if there is poweer to the right pump... if there is power there then the pump is fubar R&R that... the switchover valve also needs to be checked for power.. autozone has them
__________________
Bob



1951 International running on a squarebody chassis


"If a man's worth is judged by the people he associates himself with, then i am the richest man in the world knowing some of the fine people of this board"
http://67-72chevytrucks.com/vboard/a...t.php?f=25&a=9 (you can review the site rules here!)


PM Me for your vehicle/parts hauling needs in the North East US or see my Facebook page Robert Olson Transport

Live each day to the fullest.. you never know when fate is going to pull the rug out from under you...
I hate cancer!!
old Rusty C10 is offline   Reply With Quote
Old 08-26-2009, 02:34 PM   #6
92470
Registered User
 
Join Date: Nov 2006
Location: Maple Grove, MN
Posts: 149
Re: Tank 2 problems

I have the same problem on my 87' V10 and am planning on repairing it this weekend. I posted a previous question about this on how to troubleshoot, and the answer I got helped me out a bunch. When you turn your ignition key on, you should hear the fuel pump "hum" on the side that you have your selector switch switched to (LH or RH). My left works, my right doesn't. When I switch my selector switch to right and turn on my key, no hum. When on the left, it hums. I.e right fuel pump is out. I know the selector valve on the frame is working, because when I turn the key, I hear it click. I bought a new AC Delco valve just to check, and when I hooked it up, it clicked and performed just the same, so I'm planning on taking it back because it was $140, but I figure I'll wait just to be sure until I have the pump replaced. While I have the tank out to replace the pump, I'm also replacing the sending unit just in case. I hope this helps you fix your problem. If my advice is not correct, someone please correct me. Good luck!
92470 is offline   Reply With Quote
Old 08-26-2009, 02:49 PM   #7
bumslie75
Registered User
 
bumslie75's Avatar
 
Join Date: Apr 2009
Location: Reedley Ca
Posts: 360
Re: Tank 2 problems

I have the same problem is it the right tank or the left for you
__________________
"There he goes. One of God's own prototypes. A high-powered mutant of some kind never even considered for mass production. Too weird to live, and too rare to die."
bumslie75 is offline   Reply With Quote
Old 08-26-2009, 03:24 PM   #8
chuckthetruck
Registered User
 
chuckthetruck's Avatar
 
Join Date: Jul 2009
Location: Moberly MO
Posts: 59
Re: Tank 2 problems

right tank
chuckthetruck is offline   Reply With Quote
Old 08-26-2009, 04:03 PM   #9
bumslie75
Registered User
 
bumslie75's Avatar
 
Join Date: Apr 2009
Location: Reedley Ca
Posts: 360
Re: Tank 2 problems

ya its my right tank too
__________________
"There he goes. One of God's own prototypes. A high-powered mutant of some kind never even considered for mass production. Too weird to live, and too rare to die."
bumslie75 is offline   Reply With Quote
Old 08-26-2009, 05:04 PM   #10
nlped
Senior Member
 
nlped's Avatar
 
Join Date: Jul 2009
Location: Hayden, Al.
Posts: 4,148
Re: Tank 2 problems

Me Too!!! Stupid right tank!
__________________
Carter

1968 Chevy SWB Fleet... Walt


1963-1/2 Ford Falcon Futura...Martha
nlped is offline   Reply With Quote
Old 08-26-2009, 05:11 PM   #11
orbot
Registered User
 
orbot's Avatar
 
Join Date: Jan 2008
Location: Chula Vista, Ca
Posts: 518
Re: Tank 2 problems

Is the switch pluged??

There is a plug on the firewall, see if its conected....

Can you hear the selector valve when you press the switch??
orbot is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 02:48 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com