|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
08-29-2011, 05:06 PM
|
#1 |
|
Registered User
Join Date: Jul 2009
Location: Bellingham, WA
Posts: 40
|
bed angle strip spacing
This is for an early 50 bed. The PO fancied himself as a custom installer and drilled the holes different on the angle strip both sides and bolted in a piece of plywood with a finished thin plywood over it. Now I am getting ready to put it back to stock and would like to know the bolt hole spacing front to back so I can repair and redrill the angle strip. I am going to repair the angle strip as the exterior paint is very good.
Thanks |
|
|
|
08-29-2011, 08:13 PM
|
#2 |
|
Registered User
 
Join Date: Jul 2007
Location: Toppenish, WA
Posts: 15,711
|
Re: bed angle strip spacing
94 degrees and he has me out back measuring a bed side.
OK measuring from the end of the bed side (not the end of the angle)  2 14-3/4 27 40-3/8 53-7/8 76-1/2 That was as close as I could get to the centers of the worn holes in this bed side. The 2 may be closer to 1-3/4 as that hole is pretty well worn. |
|
|
|
|
08-29-2011, 08:21 PM
|
#3 |
|
Registered User
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
|
Re: bed angle strip spacing
Hopefully you will get a cold beverage out of it....
Be glad you could have been out in the yard searching under 2' of water for the parts....
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project |
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
