How much extra threads on U bolts need to stick out to be able to run a drop block?..

[oldblue1968chevy]

Looking under my truck earlier, noticed I have a little over an inch sticking down past the nuts. How much extra threads will I need (say if I ran a 1" block) to stick out?

This make sense? I'll try to get pix

And is it 7/8 or 3/4" hole?

[tubbedII]

Given how many foot lbs is needed to torque these down, I'd be comfortable with just a few threads being visible...in fact, I cut mine down after torquing anyways.

I don't know the hole size, but I'm pretty sure the bolt size is 1 1/4".

[oldblue1968chevy]

TTT

I have 1 1/8" of thread sticking past the nut (maybe a bit more but 1 1/8" to be safe).

So could I squeeze a 1" drop block in there

[lolife99]

Originally Posted by oldblue1968chevy

TTT
I have 1 1/8" of thread sticking past the nut (maybe a bit more but 1 1/8" to be safe).
So could I squeeze a 1" drop block in there

Yes.
I drill my drop blocks with a 7/8" drill bit.
The u-bolts should be 3/4" diameter.

[N2TRUX]

I would replace the U-bolts and add the block you want. U-bolts are cheap to buy so why risk it.

[oldblue1968chevy]

U bolts are new....(less than a year..)

[oldblue1968chevy]

So I wanna lil extra room-Do you think the 1 1/8" is enought to sqeeze a 1" block

[lolife99]

Originally Posted by oldblue1968chevy

So I wanna lil extra room-Do you think the 1 1/8" is enought to sqeeze a 1" block

Again,... YES.

I use drop block to gain the maximum drop.
My first choice would be drop springs.

[oldblue1968chevy]

Do they make a HD dropped spring lolife (you would know)?

I only want 1-3" (realize 3" shouldnt be attempted with a block).

[lolife99]

Originally Posted by oldblue1968chevy

Do they make a HD dropped spring lolife (you would know)?

I only want 1-3" (realize 3" shouldnt be attempted with a block).

Not that I know of.

[oldblue1968chevy]

I didnt know, thought burbs or 3/4 tons might have their own drop spring

[project 67 sub]

i have heard that the burbs do have their own drop springs for the rear do to being heavier, as far as 3" blocks they can be done (i have some i made on my burb but i run 20" wheels) but no more than i believe a 2" block is recommended with 15" wheels

[oldblue1968chevy]

Called fastenall, there checking some prices for me on 2" u bolts (already have blocks ready).

Going down to Tampa Bay Fl area for the next 2 weeks, I located some spring shops so hopefully I can get some U bolts made on the cheap. Anyone know if they'll let you take 2 u bolts on a airplane, or should I try to flat rate box them to myself in TN LOL

[fishingjred73]

http://67-72chevytrucks.com/vboard/s...d.php?t=454824

[oldblue1968chevy]

seen it already-trying to do it REAL cheap if I can thanks for the link though others might benefit

[lolife99]

Don't get too cheap.
It's your suspension you are talking about.
Spend a few bucks and do it right.
Contact member way2lo2.
Posted via Mobile Device