|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
12-14-2011, 11:48 AM
|
#1 |
|
Account Suspended
Join Date: Dec 2008
Location: indisclosed
Posts: 1,515
|
Dual wheel conversion:
Would adding dual wheels to a 3/4 ton, or single rear wheel 1-ton put any undue stress on the rear axle---specifically the drum/mounting flange/axle bearings/studs etc.?
i don't know if the 3/4 has the same rear axle as the 1-ton---full float or semi float? |
|
|
|
12-14-2011, 02:18 PM
|
#2 |
|
Registered User
Join Date: Dec 2010
Location: Pittsburgh, PA
Posts: 1,009
|
Re: Dual wheel conversion:
What year 3/4 ton? IIRC, they switched from the 14 bolt FF (same as 1 tons) to the 14 bolt SF sometime in the late 70's.
__________________
Steve Member of the Foot Pedal Club '83 Chevy K20: 6" Rough Country, 3" Performance Accessories BL, Bushwacker Cutouts, 38x15.50 Mickey Thompson Baja Claws, 350 HP 350 crate engine from Jegs, Turbo 400 
|
|
|
|
|
12-14-2011, 10:40 PM
|
#3 |
|
Account Suspended
Join Date: Dec 2008
Location: indisclosed
Posts: 1,515
|
Re: Dual wheel conversion:
Let's say 82-87.
Or 88-97ish. |
|
|
|
|
12-15-2011, 08:24 AM
|
#4 |
|
Registered User
Join Date: Jun 2008
Location: Lubbock, TX
Posts: 2,047
|
Re: Dual wheel conversion:
Doesn't really matter...any 8-lug rearend will handle a lot more than what you're talking about doing. The semi-floater actually has bigger axle shafts, 33 spline honkers.
|
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
