|
|
|
07-01-2013, 12:47 AM
|
#1 |
|
Registered User
Join Date: Dec 2012
Location: houston texas
Posts: 10
|
floor shifter removal
HI HOW DO YOU REMOVE THE FLOOR SHIFTER ON 1972 1/2 TON C 10 IT IS A 4 SPEED I REMOVED THE FLOOR BOOT , BUT DONT SEE HOW TO REMOVE IT LOOKS LIKE IT HAS A HOLLOW PIN THROUGH THE ROUND BALL THAT THE SHIFTER IS CONNECTED TO ANY HELP IS APPRECIATED STEVE
|
|
|
|
07-01-2013, 01:01 AM
|
#2 |
|
Proprietor of Dale's Corner
 
Join Date: Nov 2012
Location: Vacaville , CA
Posts: 16,297
|
Re: floor shifter removal
Make sure it's in neutral, then push down on the "ball" and turn counter clockwise a quarter turn and then lift the shifter straight up and out. Hope this makes sense to you
Posted via Mobile Device
__________________
"Some Days Chickens And Some Days Feathers" Dale XNGH ECV Sam Brannan 1004 R.I.P. 67ChevyRedneck R.I.P. Grumpy Old Man R.I.P. FleetsidePaul |
|
|
|
|
07-01-2013, 03:02 AM
|
#3 |
|
Registered User
Join Date: Dec 2012
Location: houston texas
Posts: 10
|
Re: floor shifter removal
Thinks for the info
|
|
|
|
|
07-01-2013, 06:35 AM
|
#4 |
|
Senior Member
Join Date: Feb 2002
Location: Tucson, AZ USA
Posts: 7,582
|
Re: floor shifter removal
GM techs used to have a special tool, but I've seen guys do it with a big pair of channel locks. Sometimes I cut 5/8'' wide notch in a short 2x4 stud, about 1-1/2'' deep --push down and twist.
__________________
Every 25 years I like to rebuild that 292, whether it needs it or not. |
|
|
|
|
07-01-2013, 08:12 AM
|
#5 |
|
Registered User
Join Date: Jan 2013
Location: Eastern TN
Posts: 1,921
|
Re: floor shifter removal
Same premise but the easiest way is to put a large screw driver in the corner of the retainer (where it makes the 90* turn) then smack it downward and counter clockwise at about a 45 degree angle. Pops right out that way. This is the way I have alwasy done them. Use a screwdriver with a good blunt tip.
|
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
