|
|
|
03-12-2014, 11:09 AM
|
#1 |
|
Registered User
Join Date: Feb 2014
Location: Spicewood, TX
Posts: 3
|
Lowering Question
I am getting ready to lower my 51 3100. In the process of changing out the rear differential fluid I discovered that the previous owner most likely changed out the rear end and put in a rear end from a 58.
Was considering using 3" blocks in the back that I can order from chevyofthe40s.com for a 51 but I am concerned that they will not work on the 58 rear end. Does anyone have any advice or suggestions on the blocks or other ways? Thanks Andy |
|
|
|
03-12-2014, 12:39 PM
|
#2 |
|
Happy to be here
 
Join Date: Mar 2000
Location: Cypress, TX
Posts: 39,021
|
Re: Lowering Question
Welcome to the forum Andy_g. Lets see if we can get an answer to your question.
__________________
Follow me on Facebook and Instagram @N2trux.com Articles- "Jake" the 84 to 74 crewcab "Elwood" the77_Remix 85 GMC Sierra "Scarlett" "Refining Sierra" |
|
|
|
|
03-12-2014, 02:24 PM
|
#3 |
|
Registered User
Join Date: Jan 2014
Location: Peoria, IL
Posts: 1,450
|
Re: Lowering Question
More than likely they just swapped the center section of the rearend. The 55 and newer were spring over. The AD trucks were spring under with a torque tube. The AD trucks had their own proprietey brackets welded to the axle, so I doubt he changed the whole rearend.
To answer your question, yes the blocks will work. |
|
|
|
|
03-13-2014, 10:24 AM
|
#4 |
|
Registered User
Join Date: Feb 2014
Location: Spicewood, TX
Posts: 3
|
Re: Lowering Question
Thanks alot guys. You are right whitedog. The brackets for the springs are welded to the axle. Sounds like that is what they might have done. This may not be a smart question but why would they have done this swap?
Thanks again for the help. |
|
|
|
|
03-14-2014, 09:35 PM
|
#5 |
|
Registered User
Join Date: Feb 2014
Location: Spicewood, TX
Posts: 3
|
Re: Lowering Question
Has anyone used drop spindles to lower?
|
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
