|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
03-21-2014, 10:28 PM
|
#1 |
|
Registered User
 
Join Date: Jul 2013
Location: branford, connecticut
Posts: 201
|
Tools needed / recommended to install porterbuilt suspension
Hello All
I am going to be putting in a front / rear porterbuilt suspension. (Cannot wait  What tools do you all recommend I have available. I have a friend who will weld for me. I am talking about drills, saws, crutters, grinders. Thanks for the info in advance. I am going with the mild rear with the touring front. |
|
|
|
03-21-2014, 11:27 PM
|
#2 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,066
|
Re: Tools needed / recommended to install porterbuilt suspension
High quality air hammer/chisel for popping rivets (cheap ones will take longer to bust them off).
Quality drill bits (multiples of the 1/2" size). Angle grinder w/a cut off wheel & various 36 + 60 grit sanding discs. Tape measure. Level/s. Another good thing to have around are misc pcs of angle steel to help align/square/clamp things (ex: R&P notches) in place. I used 1.5x1.5 3/16 steel..... And most important.... If someone like me is helping, cold frothy beverages will be required for the most accurate results  .
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
03-24-2014, 09:34 PM
|
#3 |
|
Registered User
Join Date: Jul 2013
Location: branford, connecticut
Posts: 201
|
Re: Tools needed / recommended to install porterbuilt suspension
Ttt
|
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
