|
|
|
06-24-2015, 11:47 PM
|
#1 |
|
Registered User
Join Date: Sep 2013
Location: Airdrie, AB
Posts: 78
|
Vent window on a '54
So, I got all the innards out of a door today, but can't figure out the vent window assembly. Took the 2 bolts and 3 sheet metal screws out and can get the unit to move back and forth a couple of inches, but it seems to be binding on something else. Regulator and window channel are out, any ideas?
|
|
|
|
06-25-2015, 02:36 PM
|
#2 |
|
Registered User
Join Date: Sep 2013
Location: Airdrie, AB
Posts: 78
|
Re: Vent window on a '54
Problem solved. There's a bolt way down at the bottom of the slider channel. Difficult to get at and I had to prevent the post from rotating with the torque applied to the bolt. Ended up measuring the location and cut a 2x3 hole with the dremel and cutoff blade, to allow access.
I'll either make a panel to cover the hole or weld the cutout piece back in. |
|
|
|
|
06-25-2015, 02:43 PM
|
#3 |
|
Registered User
 
Join Date: Jul 2007
Location: Toppenish, WA
Posts: 15,731
|
Re: Vent window on a '54
That bolt you need an arm with a second elbow between your wrist and elbow to get to along with slim arms rather than big guy arms.
__________________
Founding member of the too many projects, too little time and money club. My ongoing truck projects: 48 Chev 3100 that will run a 292 Six. 71 GMC 2500 that is getting a Cad 500 transplant. 77 C 30 dualie, 454, 4 speed with a 10 foot flatbed and hoist. It does the heavy work and hauls the projects around. |
|
|
|
|
06-29-2015, 05:10 PM
|
#4 |
|
Registered User
Join Date: Sep 2013
Location: Airdrie, AB
Posts: 78
|
Re: Vent window on a '54
The other headache was that the channel attached to the vent was twisting, so had to go in the top with a 17mm wrench to prevent the turning
|
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
