Cpp control arms for a airbag

[Bagged1972]

Hey folks I am think about ditching my cupped control arms on 72 for a set of cpp arms so I was wondering if anyone had a picture of the control arms for airbags cause all they could tell me is that it has provisions for the ride tech mounting brackets so I don't know if these will work with my DOM 2600 bag. And another thing before I make the purchase are they really worth the money cause I've heard that it will get the front a little bit lower.

[lolife99]

I remember old threads about CPP a-arms for bags having a small area to mount the bag. Meaning,... you would have to run a 2500 bag up front to keep from rubbing the sides of the bag on the a-arm.
In my opinion there are better a-arms.
Porterbuilt or Ridetech would be my first choice.
No a-arm is going to get you lower than the cross shaft that is bolted to the crossmember.
This is the lowest point on these trucks.

You need to get a sectioned crossmember, z'd frame, or aftermarket crossmember like the Porterbuilt Dropmember, to get your suspension higher in the frame rails, to get the front lower to the ground.

[Bagged1972]

Thanks lolife99 I'll look into Porterbuilt

[andrewmp6]

Yeah i could get arms made just for bags you will be happier in the end.

[bbbc10]

Also there is mmw that makes arms thats what i have for my truck

[Bagged1972]

Originally Posted by bbbc10

Also there is mmw that makes arms thats what i have for my truck

I checked out the mmw website but I didn't see anything for trucks like ours

[andrewmp6]

He has these for the 73-87 http://michiganmetalworks.com/store/...product_id=120 they should work on a 72 back

[lolife99]

Originally Posted by andrewmp6

He has these for the 73-87 http://michiganmetalworks.com/store/...product_id=120 they should work on a 72 back

They will work on 63-72 trucks also,... but you need to order them with the correct balljoints for the year of spindles you are using,... since balljoints are included,