CA WTB Factory 4x4 steering arm

[Jesse B.]

Hello,

I have 1969 4x4 Blazer and am looking for a factory height steering arm. The PO installed a steering arm for a lift and it is too high and results in bump steer. The steering arm that I am looking for attaches to the top of the driver side knuckle with three studs and then connects to the drag link with a tie rod end. I can provide a picture if necessary. Thanks.

[Jesse B.]

I've attached a couple pics of the arm I am looking for.

[bonestock72]

Hi Jess, finally getting back to you, sorry for the delay. This is the factory steering arm, I have several of these trucks, and they all have the same arm, with the same numbers cast into them. Let me know if this is what you are looking for.

[Jesse B.]

Thank you Bonestock. I was able to find one off a 1980 1/2 ton truck. It has different casting numbers, but appears to be identical to your pics.

[bonestock72]

Wildbore here s the top and bottom of the dropped steering arm showing the original part number. Thanks, Ken

[tim71]

Is that steering arm available? I'm in the process of removing the lift from my 71 K1500 and will be in need of a stock steering arm.

[bonestock72]

Tim, The stock 71' is gone. I have a stock 73 available, IDK if that will work for you. Ken

[Jesse B.]

Let me send you a PM. Thanks