Door Window alignment

[mpalmer03]

Any tips on realigning the window/window channel on '69 to center it in the door? Installing new rubber window wipers that clip in on top of door but the window is not centered in the opening, therefore, the window won't go up & down smoothly without rolling the rubber every time. Thanks

[LockDoc]

Originally Posted by mpalmer03

Any tips on realigning the window/window channel on '69 to center it in the door? Installing new rubber window wipers that clip in on top of door but the window is not centered in the opening, therefore, the window won't go up & down smoothly without rolling the rubber every time. Thanks

Did you also replace the window channel all the way around the window? That is what keeps the window centered. If the felt channel is worn out the window will not center itself. The only other thing that could affect alignment is that one of the rollers on the window regulator is not in the track correctly, but that usually makes the window roll up cockeyed. There are two rollers that fit into the track on the bottom glass channel and one roller that fits into a track on the inside of the door panel. (see picture with track labeled in red)

LockDoc

[slikside]

Sub'd.

[bcfishon]

Sometimes the metal plate roller guide thingy on the bottom of the window is off center and will cause the window to be too far forward or back causing the window to pinch when going up and often it's the worst coming down.

[mpalmer03]

Thanks for the replies on my door issue, including the schematic. Sorry for the delayed response. The issue looks to be the divider bar for vent window. It isn't centered in the window slot and the window is too tight up against the inside of door instead of being centered. This is putting too much pressure on one side resulting in the rubber wiper to fold up and down as window is rolled up/down. Is there a way to center the divider bar so window is equidistant in slot?

[LockDoc]

Originally Posted by mpalmer03

Thanks for the replies on my door issue, including the schematic. Sorry for the delayed response. The issue looks to be the divider bar for vent window. It isn't centered in the window slot and the window is too tight up against the inside of door instead of being centered. This is putting too much pressure on one side resulting in the rubber wiper to fold up and down as window is rolled up/down. Is there a way to center the divider bar so window is equidistant in slot?

As long as the vent window has the 3 screws through the door frame into the vent frame and the two screws through the inner door into the bottom of the vent window channel it is a fixed window, there is no adjustment. As I mentioned before the felt window channel provides the alignment. If it is bad or the window is not in the channel correctly it could cause the problem you are seeing. Looks like you will have to remove the inside door panel and check everything out. Take some pictures and post them up so we can see if anything looks out of place......

LockDoc