|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
12-26-2018, 12:08 PM
|
#1 |
|
Registered User
Join Date: Dec 2016
Location: Menifee,ca
Posts: 65
|
Moog ball joint on cpp upper tubular
I have brand new moog upper ball joints that were going into rebuilding my old set on my 1968 c10. Ended up buying cpp's upper tubulars. Uppers are new from cpp but would like to put my new MOOG's in and use cpp's as back up. This is a frame off and since I've heard nothing but good about MOOG i want to start off with them. QUESTION is do i put the MMOG ball joint in as recommended by MOOG (from the top) or put them in like CPP does theirs (from the bottom)
thanks for any help |
|
|
|
12-27-2018, 09:14 AM
|
#2 |
|
Registered User
Join Date: Feb 2011
Location: Parkville, MD
Posts: 1,024
|
Re: Moog ball joint on cpp upper tubular
I would say to do it the way CPP recommends. They designed the control arm, they know the geometry. Might call or email them and ask them to be sure.
__________________
1970 C20 Custom Camper - 350, TH350 1997 GMC Suburban 1994 Acura Integra GSR 1987 Dodge Daytona Shelby Z |
|
|
|
|
12-27-2018, 08:24 PM
|
#3 |
|
Registered User
Join Date: May 2017
Location: Goodyear, AZ
Posts: 70
|
Re: Moog ball joint on cpp upper tubular
Why not just leave it the way it is and use the moog as backup? I have both moog and cpp suspension/steering parts and they are both good quality..
|
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
