The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1969 - 1972 Blazers and Jimmys Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 02-18-2019, 08:15 PM   #1
ScottyTightdog
Registered User
 
Join Date: Jun 2018
Location: Rome, Ga
Posts: 11
Brake help!!! Danger!!

So I rebuilt my drum brakes this weekend. Everything new drums, cylinders, all new small parts/springs/etc. I go out for a test drive and initially they weren’t great but I assumed it would take a couple stops for them to grab. As I thought they started working pretty good after a couple slow stops. Took it on the highway and hit them pretty hard a few times with good stops. So I headed back to the house and as I was coming to a stop sign I hit them and had no stopping power!!!! Just had to roll on through, pedal was pretty firm, tried pumping them but had no stopping power. Went down the road a little and they worked fine again. Worked several more times until I got back to my street and same thing happened had to roll right on by my driveway and fortunately I was going slow enough to make the u turn in my cul de sac. So any ideas on why they would work fine and then not at all?
ScottyTightdog is offline   Reply With Quote
Old 02-19-2019, 12:23 AM   #2
Blazerowner
Senior Member
 
Blazerowner's Avatar
 
Join Date: Apr 2006
Location: Yuba City, Ca
Posts: 1,956
Re: Brake help!!! Danger!!

You might want to take them apart and see if they are sticking. There are some grease points where they move on the backing plate. Check out the site below. I used it to do mine. It’s pretty easy to put comething in wrong.

https://www.pbase.com/nufsed/drumbrake
__________________
Kirk
72 Blazer CST 4wd highlander
Blazerowner is offline   Reply With Quote
Old 02-19-2019, 09:21 AM   #3
Mike C
Registered User
 
Mike C's Avatar
 
Join Date: Dec 1999
Location: Austin, TX, USA
Posts: 7,727
Re: Brake help!!! Danger!!

Did you manually adjust the shoes out to where they were touching the drums pretty much when you put them back on? If you did not, it’s possible for the pistons to overextend from the wheel cylinder causing a leak. It’s possible for the springs to pull the piston back in the bore then setup a repeat of that. That’s the only thing I can think of that would cause complete brake loss, or near, and then have it come back?
__________________
44 Willys MB
52 M38A1
64 Corvette Coupe
68 Camaro 'vert LT1 & TH700
69 Z/28 355 12.6's @110
69 Chevy Short Step 4 1/2"/7" drop
72 Jimmy 4WD 4spd 4" & 35's
02 GMC 2500HD 4x4 Duramax
Mike C is offline   Reply With Quote
Old 02-19-2019, 01:53 PM   #4
ScottyTightdog
Registered User
 
Join Date: Jun 2018
Location: Rome, Ga
Posts: 11
Re: Brake help!!! Danger!!

Quote:
Originally Posted by Mike C View Post
Did you manually adjust the shoes out to where they were touching the drums pretty much when you put them back on? If you did not, it’s possible for the pistons to overextend from the wheel cylinder causing a leak. It’s possible for the springs to pull the piston back in the bore then setup a repeat of that. That’s the only thing I can think of that would cause complete brake loss, or near, and then have it come back?
I thought I had them adjusted pretty good and they seemed to be working right while I bled them but I’ll double check. Thanks.
ScottyTightdog is offline   Reply With Quote
Old 02-19-2019, 03:21 PM   #5
SeventyOne
Registered User
 
Join Date: Mar 2007
Location: Oakland, Ca
Posts: 1,382
Re: Brake help!!! Danger!!

Front brakes dont work either??

Fluid level in the resevior good?
SeventyOne is offline   Reply With Quote
Old 02-19-2019, 08:30 PM   #6
litebulblsc
Registered User
 
litebulblsc's Avatar
 
Join Date: Aug 2006
Location: LaSalle Mi
Posts: 525
Re: Brake help!!! Danger!!

Did you remember to replace them with disc brakes?
litebulblsc is offline   Reply With Quote
Old 02-19-2019, 09:36 PM   #7
WorkinLonghorn
Senior Member
 
WorkinLonghorn's Avatar
 
Join Date: Dec 2006
Location: Studio City, Calif.
Posts: 2,886
Re: Brake help!!! Danger!!

Power brakes or manual? If Vacuum assist, check the vac line to the reservoir/assist unit. Check the reservoir for ability to hold a vacuum.
If manual brakes, they are the dual system (starting in '69 i believe) so if both front and rear were KNOWN to be working and then suddenly not working with a firm peddle then you have something wrong between the peddle and the distribution block. Did you bleed the MC? Do you have the warning light operational that shows pressure differential between front and rear systems? You need to look into this area.
__________________
'69 GMC C2500 Custom Camper, 8 1/2' bed, New GM 350, NP 435 Close Ratio 4spd. Trans., 3.73 Dana-60 open.Camper and Trailer wiring, PS, PB, AC, tach , three gas tanks, stereo speakers, 2nd owner, Work-Truck supreme.
WorkinLonghorn is offline   Reply With Quote
Old 02-19-2019, 11:15 PM   #8
Ewr101
Registered User
 
Ewr101's Avatar
 
Join Date: Dec 2014
Location: Spring, Tx
Posts: 244
Re: Brake help!!! Danger!!

I would check the set up you did to a known good pic for comparison. You can find one either on this site or online. If that checks out put the drum back on and adjust the star wheel till you just begin to feel the shoes engage. Then do a few stops in reverse. Make at least one a semi abrupt stop. That's what will cause the star wheels to adjust the shoes properly. I redid my rear drums, EVERYTHING new, just like you and the drums didn't have the slot to adjust the star wheel. I did the instructions above and it stops amazingly well for a big heavy Blazer. Good pedal feel as well.
__________________
72 Chevy 2WD Blazer
Ewr101 is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:46 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com