350 block for sale

[Nvbowtie]

350 4-bolt main bored 40 over,

<45> minute break-in / run time.

I noticed the outer starter hole was cracked, and chose to buy a new block, the machine shop said this would not affect the engine, but I prefer to not be changing starter nose cones and what not. This would be a excellent block for someone with a standard tranny, due to starter mounts on bellhousing.

The block will come with the cam left in it, since I broke it in already.
The cam is a competition cams: 280/480 lobe sep 112
http://www.unlimited2u.com/engine

Looking to get a fair price to recover expense of change-out, I may consider selling entire motor (long block) if you contact me ASAP.

block w/cam 375.00 entire long block 1200.00

cdtek@cmaaccess.com - 702-420-6354

-Bill, Laughlin, Nv.

[Nvbowtie]

No one with a 4-speed needing a block ??

This is a great block for someone,

only 45 minutes on the rebuild !!!

(just not for a automatic, unless you wanted to repair the hole.)

Make me an offer !!

Block price 125.00
Block work 125.00
Cam/bearings/lifters 125.00
======
375.00 OBO

[phantom dually]

Honestly I can have a block bored and all bearings put into it for that price. Thats with a cam also.

[Nvbowtie]

Originally posted by phantom dually
Honestly I can have a block bored and all bearings put into it for that price. Thats with a cam also.

Exactly what I posted, just wanting a fair price, I'm not looking
for a profit.

Does yours include buying a block ?
And shipping from Kentucky to the Las Vegas area ?
*****If so I'll buy a few blocks from ya!!******

I am not trying to compare to back east prices, I am
looking for a local buyer in the Las Vegas area.

If I were back in my home state of Arkansas, I could get
it cheaper also, but this is higher cost area, with all the
big lights and slot machines.

Ohhh, just noticed your selling a 406, good luck on it,
it would make a great stocking stuffer for someone.

Here's my breakdown of original cost;

125.00 Block price
75.00 Block -Hot tanked/Jetted
80.15 Block Surfacing
180.00 Block bored and honed
150.00 Cam/bearings/lifters (Installed) Comp Cam 280/480/112
20.00 Freeze plugs (installed)
=====
630.15 ----------> 375.00 OBO

[phantom dually]

Yeah I never considered where you are located. Around these here hills we can get a blocked bored with a plate for $120-$140 max. The 406 is just a project motor. I buy em at a fair price and build them for the hooby part of it and make a few $$ in the process.

[phantom dually]

I just bought a 86 and up roller block from a machine shop for $200. 30 over fresh bore and hone new cambearings and main bearings. I have done alot of work with this guy.

[Nvbowtie]

ttt