Wiper tubing what keeps it on

[bennylava]

Maybe a dumb question but my windshield spray nozzle tubing keeps popping off. It's the one next to the windshield wiper, that supplies bugwash to the spray nozzle. The passenger side tube stays on fine, but the driver's side pops off all the time.

Any way to keep it on? Some kind of tiny band clamp? Thanks!

[Getter-Done]

The hose is a little smaller than the push on fitting.
This creates a press-fit.
If the hose is older? replace the one cause the issue.
This would look the best.

Or use a twist wire method.
Careful not to snap the fitting by twisting it to tight.
Or a real small hose clamp.

[400/400]

Like Getter-Done mentioned, it’s a press-fit. If there is enough slack you can trim the end and get some fresh material to press on. I’ve also had good luck with small zip ties used as a hose clamp.

[Dead Parrot]

If the cut off a bit and re-fit doesn't work, some motorcycle fuel lines use a small spring clamp. They are about the same size as the washer fluid tubing.

[rdc72]

A small 3" zip tie will work, just trim the excess.

[rodstored-72]

Originally Posted by rdc72

A small 3" zip tie will work, just trim the excess.

this is what I did for my '86 when I re built it.. I might have a pic in my build thread.

[87chevy.com]

maybe if its a new hose and its still a problem? maybe take off the metal line, and use a spring loaded center punch to flare the end of the tubing out a little bit..?

be less obvious than a zip tie or clamp and might be a good solution?

[bennylava]

Thanks for the replies all, I will just get some new tubing. Didn't know it was a press-fit.

Anyone happen to know the size? What would that be... 1/16" tubing perhaps?

[Dead Parrot]

Take a piece of the old hose with you. Get rid of the last inch or so where it has expanded so the parts person sees a fresh end. Used to be you just asked for vacuum hose/washer hose. It was all about the same size across mfgs. Now it seems there are lots of 'special' sizes.

[v30crewcab]

a little hairspray in the end and install it and let it dry. should hold.

[Dead Parrot]

Check with a chainsaw/small lawn device repair shop. Some of the gas lines on those are about that size.

[rick1956]

What you're looking for is 3/32" I.D. but is semi hard to find because so many distributors only carry metric hose. Gates makes the exact hose product you're looking for if you want your washer hose to snake through the arm springs like the OEM hoses were. It's Gates part# 27030 'wet arm vacuum hose' by name. If you are okay with zip-tying the hose underneath the arm any 3mm hose they carry will likely work.

I put a little info about it here on my blog: https://rixsquarebody.blogspot.com/2...-84-to-85.html

[bennylava]

That is still pretty thick, the hose I have looks more like the image in this pic:

https://www.amazon.com/MECCANIXITY-V...thin+wall+hose

See how the wall is quite thin. Not the right size, but the image shows the correct proportions. Still haven't found anything yet, except for yellow weedeater fuel line.