|
11-12-2004, 02:21 AM
|
#1 |
|
Registered User
Join Date: Nov 2003
Location: East Bethel, MN
Posts: 27
|
Control arm question?
Are the upper control arms the same through the different chassis?
Basically is a 1/2 ton upper the same as a 1 ton or 3/4 ton Thanks |
|
|
|
11-15-2004, 02:12 PM
|
#2 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
The upper arms should be the same, but you may find a difference in the shaft/bushings. I converted my 3/4 to 1/2 ton suspension, & didnt mess with the upper arm or shaft(just swapped the ball joints). the lower arms are for sure different , due to the hole size for the balljoint. its been a while, but as memory has it the upper arms 10-30 series are the same.....the shaft is beefier on the 20 & 30 series tho. hope that helps some....crazyL
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
