aired out with no x member of z

[fossilrunner]

does any one have any pics of their trucks aired out with no x member notch of frame z'd.So pretty much alls that is done is stock control arms or tubular ones.

[lvscott]

here is a link to mine. 29" tall tires in front, 31" tall tires out back. it has strong arms with bags aired out. rear has no springs or shocks and bags are not installed yet. hope this helps.http://www.cardomain.com/member_page...814_1_full.jpg

[project76]

lvscott in your pic is the k-member sitting on the ground up front? And is the frame sitting on the axle tubes in the rear?

[Hart_Rod]

Here are some links to my 69 Suburban w/bags:

http://67-72chevytrucks.com/vboard/s...d.php?t=174330

http://67-72chevytrucks.com/vboard/s...d.php?t=175454

[lvscott]

Originally Posted by project76

lvscott in your pic is the k-member sitting on the ground up front? And is the frame sitting on the axle tubes in the rear?

the cross member is about a inch off the ground. and yes the frame is sitting on the tubes. i just installed a cpp c-notch, i'm out of town right now, but when i get back i'll take some more picks and post those so you can see how it looks. also i have three inch drop spindles from djm

[N2TRUX]

No X, no Z, but 3" dropped spindles.....

[Hart_Rod]

LVSCOTT - I'm getting ready to do the c-notch on my 69 Suburban, were there any problems and do you have any Pics? Thanks,

Rob

[lvscott]

Originally Posted by Hart_Rob

LVSCOTT - I'm getting ready to do the c-notch on my 69 Suburban, were there any problems and do you have any Pics? Thanks,

Rob

i am doing a frame off, so with everything out of the way it was pretty easy. i used a saw zaw, but it would have been much easier with a plazma cutter. they still are not bolted in yet, but they are sitting in place. i'm not sure if i'm happy with the notch or if i'm going to have to step it. i can't seem to figure out how to post pics so check them out on this link. http://www.cardomain.com/ride/2180814/1