tilt front end? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

GMC 3 · 09-26-2002, 06:21 PM

a welder i work with is building a 72 and was thinking about trying to make a tilt front end out of his truck. I know a couple of people on here have done this and I told him I'd ask to know what steps to take and what problems you ran into. any pics would be helpful also

thank you

Alexis · 09-26-2002, 06:31 PM

i hope this might help in some way

http://www.usbody.com/

on the side menu go to 67-72chevy trucks, if you got a modem connection you better start a puzzle, lol. i'm playing might take a while to load but they have a 67 front clip kit that tilts.

MOTHERTRUCKERS · 09-26-2002, 07:10 PM

We have 2 67-8 tilt cowl front ends on order, both are part# FCGI-67e in their catalog. e-mail for prices or information.

crazy longhorn · 09-26-2002, 10:22 PM

A glass tilt would be by far the easiest way to go,& would save a little weight. my longhorn has a steel tilt that I set up over a winter,but was a lot of work. I dont have pics at this time, but would be glad to try to run over details.

09-26-2002, 06:21 PM	#1
GMC 3 Registered User Join Date: Dec 2001 Location: Philadelphia, pa. U.S.A. Posts: 87	tilt front end? a welder i work with is building a 72 and was thinking about trying to make a tilt front end out of his truck. I know a couple of people on here have done this and I told him I'd ask to know what steps to take and what problems you ran into. any pics would be helpful also thank you

09-26-2002, 07:10 PM	#3
MOTHERTRUCKERS Registered User Join Date: Dec 1999 Location: BRADENTON FLA Posts: 3,269	We have 2 67-8 tilt cowl front ends on order, both are part# FCGI-67e in their catalog. e-mail for prices or information. __________________ Rest in Peace Ed. Thanks for all the good times.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

09-26-2002, 06:31 PM	#2
Alexis Member since 2000 Join Date: Dec 2000 Location: Mountain View Ca / Mexico Posts: 7,874	i hope this might help in some way http://www.usbody.com/ on the side menu go to 67-72chevy trucks, if you got a modem connection you better start a puzzle, lol. i'm playing might take a while to load but they have a 67 front clip kit that tilts.

09-26-2002, 10:22 PM	#4
crazy longhorn Fabricate till you "puke" Join Date: Jun 2002 Location: Ill Posts: 9,402	A glass tilt would be by far the easiest way to go,& would save a little weight. my longhorn has a steel tilt that I set up over a winter,but was a lot of work. I dont have pics at this time, but would be glad to try to run over details.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.