|
12-15-2006, 01:58 AM
|
#1 |
|
Registered User
Join Date: Dec 2004
Location: El paso, Tx.
Posts: 428
|
Brake light lit
 I recently swapped out the drums to disk in the front end and after changing the complete spindles, proportioning valve, MC and booster, the brake light in the dash stays lit. I have bleed the brakes 3 times, the pads are brand new and the MC is also new. What the heck gives ???
__________________
1969 Chevy C-10 350/700r4 Last edited by el curioso; 12-15-2006 at 02:07 AM. |
|
|
|
12-15-2006, 05:37 AM
|
#2 |
|
A guy with a truck
Join Date: Sep 2005
Location: Germany, for now
Posts: 5,921
|
Re: Brake light lit
Oh, in the dash. NM... What 68c10 said.
__________________
-Chris Instagram _elgringoloco_ '70 Short-Wide How to: Ruin a perfectly good C10 ‘70 Blazer ConversionHow To: Ruin a Perfectly Good 4wd '72 Highlander How To: Ruin a Perfectly Good K/5 (SOLD) '72 Blazer 2WD How to: Ruin a perfectly good Blazer (SOLD) '05 Yukon Daily Driven (not so stock) Yukon (SOLD) ‘07 Yukon Denali (daily) Members met list: SCOTI, darkhorse970, 67cheby, 67cheby'sGirl, klmore, porterbuilt, n2billet, Fastrucken, classicchev, Col Clank, GSFMECH, HuggerCST, Spray-Bomb, BACKYARD88, 5150, fine69, fatbass, smbrouss70, 65StreetCruiser, GAc10boy Last edited by gringoloco; 12-16-2006 at 03:10 AM. |
|
|
|
|
12-15-2006, 07:01 AM
|
#3 |
|
MY EX DRIVES A BROOM
Join Date: Nov 2003
Location: Herington, KS
Posts: 869
|
Re: Brake light lit
It sounds to me like you need to reset or hook up the switch in your prop valve
__________________
They say nobody's perfect. I'm a nobody, so I must be perfect. Building Nemo -1968 C10 Long Bed FRED -1947 KB-2 International |
|
|
|
|
12-15-2006, 06:12 PM
|
#4 |
|
Registered User
Join Date: Dec 2004
Location: El paso, Tx.
Posts: 428
|
Re: Brake light lit
It has the wire connected to it. How do you reset.
__________________
1969 Chevy C-10 350/700r4 |
|
|
|
|
12-16-2006, 07:57 AM
|
#5 |
|
Registered User
Join Date: Apr 2006
Location: Grandview WV
Posts: 41
|
Re: Brake light lit
I may be wrong, but it sounds as if your master cylinder is off center. To center it, have someone pump the brakes and watch the light, bleed it slowly at the line on the master cylinder, when the light goes out tighten the line. Hope this works for you. Greg
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
