|
12-28-2002, 01:22 PM
|
#1 |
|
Registered User
Join Date: Oct 2001
Location: Pittsburgh, Pennsylvania USA
Posts: 461
|
Rear End Interchange
If my information is correct, 55-57 pickups used a six bolt axle, Hotchkiss rear housing, which the center section was removable like a 9" Ford. This is similar to or the same as the one used on most full size passenger 55-64. So the question, are truck to passenger center sections interchangeable, and are the axle splines different or the same. If you know the spline count and lengths of the trucks, then I can cross check it versus what I know about the passenger car components. My intention is to add a different center section from a truck to my collection with intention to add it to my 64 Impala at some point in time. Anyone familiar with this crossover??
|
|
|
|
12-30-2002, 12:14 PM
|
#2 |
|
"Treasure the Ride"
Join Date: Nov 2001
Location: Mid Michigan, Harrison Michigan, USA
Posts: 682
|
I hate to zero "zero" replies
LIL RED,
I don't like to see it when no one replies in these forums! So I will at least give you as much help as I can. Visit this link : http://www.drivetrain.com/ and then either email or call them with your questions. They were very helpful to me in I.D.'g my 10 bolt under my 57.    rico_bob www.ricos.rods-and-relics.com
__________________
If you think you can you're right. If you think you can't you're still right. Trucks: '56 SWB; '57 SWB; '63 C-10 Current projects: 1963 Long Fleetside for the wife! '56 for the daughter. Visit us at: www.ricos-rods-and-relics.com |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
