|
11-05-2008, 10:56 AM
|
#1 |
|
Registered User
Join Date: Feb 2001
Location: Wetumpka, Al, U.S.
Posts: 8,892
|
Show me your tubs
I'm looking to do tubs in my brother's 59. Show me what you guys used.
__________________
Kevin Special Thanks to All who have helped on the TRUCK! My Pass Time Show http://s129.photobucket.com/albums/p...Chapter1-0.mp4 So Far my best Times are: Motor only: 6.44 1/8 @ 104.13 10.39 1/4 @ 125.83 Nitrous Times: 5.785 1/8 @ 118.65 with a 1.336 60ft 9.168 1/4 @ 142.58 with a 250 shot dead out of the hole! |
|
|
|
11-05-2008, 06:59 PM
|
#2 |
|
Yellow truck club
Join Date: Apr 2006
Location: Barrie Ontario
Posts: 2,080
|
Re: Show me your tubs
Just waiting to pick mine up. I used a set from an early 60's chev p/u. Cut out about 6" from the center. I'm going to use the same type of carridge bolt to fasten it down.
__________________
................................................................ Brian ......  My hub garage address http://www.hubgarage.com/mygarage/59apache I gue$$ everything has it'$ price ALL GONE NOW   59 Chev Apache PRAISE THE LOWERED 350 700r lokar shifter power MII front end, shockwaves tilt, 4 wheel discs 4-link and bags 10 bolt limited |
|
|
|
|
11-12-2008, 04:19 PM
|
#3 |
|
Registered User
Join Date: Feb 2005
Location: Deep River, Ct
Posts: 135
|
Re: Show me your tubs
I made my tubs out of non-galvanized trailer fenders I bought on-line. I narrowed them to 2" and filled in the side. I looked closely at the discription to find some that were big enough. (I want to run 29" tires and the fenders will clear 31") They were like $25.
|
|
|
|
|
11-12-2008, 10:16 PM
|
#4 | |
|
Registered User
Join Date: Feb 2007
Location: Turlock , CA
Posts: 76
|
Re: Show me your tubs
Quote:
|
|
|
|
|
|
03-29-2009, 10:02 AM
|
#5 |
|
Registered User
Join Date: Feb 2004
Location: lynchburg ohio
Posts: 736
|
Re: Show me your tubs
Bondobob,thats a good looking job on the tubs! I read most of your post on your truck earlier.I dig it man.
|
|
|
|
|
03-29-2009, 02:25 PM
|
#6 |
|
Registered User
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
|
Re: Show me your tubs
Why not get a set of 58-59 fleetside fender tubs and narrow them to fit the tire width? They would come with the flanges for bolting to the bed and look factory.
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
