|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-21-2009, 08:44 PM
|
#1 |
|
Registered User
Join Date: Jan 2009
Location: Ontario Canada
Posts: 239
|
Whats wrong with this picture? Brace is bent?
The running board brace is bent forward on both sides as if ito accomodate the fender. Is there something wrong? Could they be the wrong fenders?
|
|
|
|
02-21-2009, 09:28 PM
|
#2 |
|
Registered User
Join Date: Dec 2002
Location: Cactus Patch So. Az
Posts: 4,749
|
Re: Whats wrong with this picture? Brace is bent?
It looks like it is up too high, does the running board lay flat on the other two braces, how about the ones on the drivers side?
__________________
53 TuTone Extended Cab 350 4-Spd 3:08 (SOLD) 53 Chevy Moldy pearl green ZZ-4 4L60E 9" 3:25 55 GMC 1st Black Mll (ZZ4) ZZ6 TKO 600 5 sp 3:73 62 Solidaxle Corvette Roman Red (327 340hp 4spd 3:36) C4 & C5 suspension tube chassis LS 3 4L70E 65 Corvette Coupe 327 350hp 4spd 4:11 78 Black Silverado SWB (350/350) 5.3 & 4L60E 3:42 2000 S-Type 3.0 (wife cruiser) 2003 GMC SCSB 5.3 4L60E 3:42 |
|
|
|
|
02-21-2009, 09:41 PM
|
#3 |
|
Registered User
Join Date: Jan 2009
Location: Ontario Canada
Posts: 239
|
Re: Whats wrong with this picture? Brace is bent?
The other side is bent forward too. I didn't check the level of the running board but to the eye, the brace looks to be at the same height as the others.
|
|
|
|
|
02-21-2009, 09:48 PM
|
#4 |
|
Registered User
Join Date: May 2006
Location: Santa Fe,Texas
Posts: 933
|
Re: Whats wrong with this picture? Brace is bent?
I think they are supposed to be bent a little. I questioned the same thing on our truck. I test fitted the running boards to verify and they seem to fit ok, but I haven't gotten to putting the bed and rear fenders on yet.
Bernie |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
