|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-05-2010, 02:09 PM
|
#1 |
|
Registered User
Join Date: Oct 2009
Location: Concord NC
Posts: 2
|
???68 K10 Power Steering Gear Box?????
So I have a 68 K10 the owner before me put in a 350 with power steering. The gear box will not sit flush to the frame cause the frame is flat not notched. I cant find any gear box for it other than the manual that will fit flush. I do not want to go back to manual gear box I use it off road with 36x13.50 Iroks. What do i need to do?? Here's a few pictures of her.
Last edited by 68mudwiser; 01-05-2010 at 02:26 PM. |
|
|
|
01-05-2010, 06:15 PM
|
#2 |
|
Post Whore
 
Join Date: Feb 2000
Location: Rose Hill, KS, USA
Posts: 12,686
|
Re: ???68 K10 Power Steering Gear Box?????
I've seen a post or two on this issue and seems the preferred route is to heat the frame and make a dimpled area to allow the box to fit correctly.
__________________
1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14 |
|
|
|
|
01-07-2010, 08:29 AM
|
#3 |
|
Registered User
Join Date: Oct 2009
Location: Concord NC
Posts: 2
|
Re: ???68 K10 Power Steering Gear Box?????
Thats what i heard too. Thank you very much.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
