|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-04-2010, 02:09 AM
|
#1 |
|
Registered User
Join Date: Nov 2007
Location: Marion, IL
Posts: 112
|
Neutral safety switch on slipped column
What can you do with the neutral safety switch (backup light switch) when the column is shortened by collapsing the Intermediate shaft? I collapsed my column 1.5 inches and the switch smashed against the firewall. (1971 - non tilt)
|
|
|
|
03-04-2010, 09:43 AM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Neutral safety switch on slipped column
It is not too difficult to relocate the switch further up the column. Cut a slot, locate and drill the mounting holes and weld in an angle to mimic the original sheet metal tab.
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
03-04-2010, 02:50 PM
|
#3 |
|
The Older Generation
   
Join Date: Aug 2006
Location: Montezuma, Iowa
Posts: 25,933
|
Re: Neutral safety switch on slipped column
__________________
Leon Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles (My Dually Pickup Project Thread) http://67-72chevytrucks.com/vboard/s...d.php?t=829820 - Last edited by LockDoc; 03-04-2010 at 02:50 PM. |
|
|
|
|
03-05-2010, 12:13 AM
|
#4 |
|
Registered User
Join Date: Nov 2007
Location: Marion, IL
Posts: 112
|
Re: Neutral safety switch on slipped column
Thanks! The two posts answered my question.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
