07-04-2003, 06:00 PM | #1 |
Alleged Member
Join Date: Jul 2003
Location: Athens, AL
Posts: 79
|
cuttin up
What is the best method for cutting up the dash to install a flat din stereo. what tool(s) work best. I have a die grinder, dremel, and jig saw and can get others if needed. |
07-04-2003, 06:08 PM | #2 |
huh?
Join Date: May 2000
Location: Washington, Illinois
Posts: 5,690
|
I've used a variable speed sawzall to make the rough cut, and the dremel to clean it up. Just measure a few times before you start hacking, and take your time
__________________
Someday when I'm lonely, Wishing you weren't so far away, Then I will remember Things we said today. RIP El Jay |
07-04-2003, 07:48 PM | #3 |
Robert Olson Transport
Join Date: Oct 2002
Location: recent transplant to NC USA
Posts: 20,310
|
remember measure fifteen times cut once!!
__________________
Bob 1951 International running on a squarebody chassis "If a man's worth is judged by the people he associates himself with, then i am the richest man in the world knowing some of the fine people of this board" http://67-72chevytrucks.com/vboard/a...t.php?f=25&a=9 (you can review the site rules here!) PM Me for your vehicle/parts hauling needs in the North East US or see my Facebook page Robert Olson Transport Live each day to the fullest.. you never know when fate is going to pull the rug out from under you... I hate cancer!! |
07-04-2003, 10:37 PM | #4 |
Senior Member
Join Date: Mar 2003
Posts: 2,499
|
I cut the plastic bezel part with a knife on a soldering iron.
I always cut plastic this way 'cause it is so quick. |
07-04-2003, 10:38 PM | #5 |
huh?
Join Date: May 2000
Location: Washington, Illinois
Posts: 5,690
|
Mike brought up a very good point on using a soldering gun/knife to cut the plastic, you get a nice edge that way....and do what Bob said, measure 15 times before you cut!
__________________
Someday when I'm lonely, Wishing you weren't so far away, Then I will remember Things we said today. RIP El Jay |
07-04-2003, 11:02 PM | #6 |
Professional Grade
Join Date: May 2003
Location: Fort McMurray, Alberta
Posts: 7,915
|
Measure, and measure again, make sure it is right, and make sure that it is level, you may have a nice clean cut, but it'll look silly if it is crooked... Take your time with it, go nice and slow and you should be fine... I am probally gonna be doing the same in my 80 soon and I am really hoping I don't mess it up...
__________________
1995 Chevrolet 2 Door Tahoe (6.6L LBZ Duramax / ZF6 / NP241 with 1 ton solid axle swap) |
07-04-2003, 11:57 PM | #7 |
Alleged Member
Join Date: Jul 2003
Location: Athens, AL
Posts: 79
|
Thanks fellas
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|