|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-19-2011, 03:24 PM
|
#1 |
|
Registered User
Join Date: Sep 2007
Location: Gray,Tennessee
Posts: 182
|
Anyone running this set up
3" drop spindles with 2"shackles in the rear riding on 18s up front and 20s out back??
i put the spindles on no problem, but when we installed the 5" flip in the rear - the drive shaft slid too far up in the tranny and also rubbed a center carrier bearing support, just too low for me. may end up with a 3 to 4 " shackle in the rear and run 18s all around. Front fenderwells are 28.75" high and the rear is 30.5" as is sits now Just thought the 2" rake on the truck now might look good with the 18/20 combo. thanks guys
__________________
'85 C-10, with 93 LT-1 & 4L60 1985 GMC, lookin' for its big block motor - SOLD '72 Chevy C-10 Cheyenne-SOLD Last edited by thebabybrahma; 03-19-2011 at 03:41 PM. Reason: add more info |
|
|
|
03-19-2011, 03:40 PM
|
#2 |
|
Registered User
Join Date: Sep 2007
Location: Gray,Tennessee
Posts: 182
|
Re: Anyone running this set up
dropped a pic for the Photo magicians to work on. thanks
__________________
'85 C-10, with 93 LT-1 & 4L60 1985 GMC, lookin' for its big block motor - SOLD '72 Chevy C-10 Cheyenne-SOLD |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
