V8 Conversion Headers - 1st Generation S10

[tcb-1]

gang,
got a friend at work that picked up an S10 project that was converted over to a V8 (350 small block). he has had a heck of a trying to find headers that will fit. does anyone have any recommendations or suggestions??

thanks!!

[v8blaze]

sanderson, patriot, and hedman make a standard (they are pretty much the exact same thing) shorty v8 swap header. They tuck in the frame, and the 3 and 5 cylinder tubes wrap around the steering shaft. Depending on how far your engine is pushed rearward you may have to a little "massaging" of the passenger side firewall below the ac box, around where the antenna goes into the body. Buts its pretty minimal and can be done with a hammer. Ive been running a set daily for around 4 years with no problems.





only pictures i have of mine, not very good but you get the idea of how snug they fit. However there isnt much stock about my engine bay but the engine went into a 100% stock truck in the beginning and everything fit

[giles70chevy]

I have a set of headers I'm not using. I think they're Headman. I can look tomorrow and let you know if you're/he's interested. I have conversion mounts too (4.3 to V8)