Roll bar with custom light bar

[HeavyC]

I search for months trying to find a set of roll bars and finally got some. They were alittle dirty but I cleaned em up best I could. Earlier today I installed the chrome roll bar with a custom made light bar to hold 5 off road lights. The light bar is made of fiberglass and adds a "spoiler" type look to it. The lights are run by 4 seperate toggle switches. One runs the outer two, the second runs the center light, the third runs the last two light. The fourth switch is for the off road lights on the bumper guard. I really like the old school/off road look of these K10s and have been searching for used parts all over. Thanks for looking...Ray

[x ReAcT x]

Looks good im impressed. Its hard to make a roll bar look good but you managed to pull it off, congrats.

[kylep]

Looks good, nice wheels too.

[HeavyC]

Thanks guys. The wiring was a b**ch for these lights. Plenty of 12 gauge wire positive (over 100 feet), 4 fuse block, lots of butt splices, 40 feet of wire insulation covering, 4 led toggle switches and 4 relays later....THEY work!! Bright was the sun.