anyone do a lsx swap with origianl 4 speed ?

[blubird]

has anyone here swapped in a lsx and used the original muncie or saginal 4 speed in here ?

[whitels1]

I'm in the process, I have information in my swap thread.

http://67-72chevytrucks.com/vboard/s...d.php?t=532351

[blubird]

is this dave ?

[whitels1]

Originally Posted by blubird

is this dave ?

Yeeeppp!

[crazy longhorn]

Not to "hijack", but the questions are along the same line. I plan a 5.3 , also with a gen I trans & bell. Does that 1050 flywheel also fit an 11" clutch? Also, what did you use for flywheel & pressure plate bolts? BTW, that looks like a nice build you have going there crazyL

[whitels1]

Originally Posted by crazy longhorn

Not to "hijack", but the questions are along the same line. I plan a 5.3 , also with a gen I trans & bell. Does that 1050 flywheel also fit an 11" clutch? Also, what did you use for flywheel & pressure plate bolts? BTW, that looks like a nice build you have going there crazyL

I bolted my original 11-7/8 clutch to the NFW1050(had to remove the alignment pins) using my original clutch bolts, I believe they are the 3/8 shouldered bolts. I used LS1 flywheel bolts.





and thanks.

[crazy longhorn]

Originally Posted by whitels1

I bolted my original 11-7/8 clutch to the NFW1050(had to remove the alignment pins) using my original clutch bolts, I believe they are the 3/8 shouldered bolts. I used LS1 flywheel bolts.





and thanks.

Thanks, that gets me a couple more pcs to the puzzle crazyL

[blubird]

Originally Posted by whitels1

Yeeeppp!

haha small world eh,this is Ali

[LEEVON]

I did it, check out my build thread linked below and this:

http://www.pirate4x4.com/forum/showt...1#post11161311

[whitels1]

Originally Posted by LEEVON

I did it, check out my build thread linked below and this:

http://www.pirate4x4.com/forum/showt...1#post11161311

Nice! I have you to thank, as your pirate build thread provided me with the essential clutch, flywheel, bearing information I needed.