|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-09-2013, 11:46 PM
|
#1 |
|
Registered User
Join Date: Apr 2012
Location: tracy, ca
Posts: 17
|
58 rocker panel replacement
Has anyone ever replaced the rocker panels on these trucks? Not the entire piece that has the step area inside the cab just the curved rocker panel that lines up with the cab corners and fenders. the cab corners have been cut out and are being replaced too. Any ideas on how I can get everything to line up?
Posted via Mobile Device |
|
|
|
01-10-2013, 12:51 AM
|
#2 |
|
Registered User
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
|
Re: 58 rocker panel replacement
Patience, they were a rough fit from the factory. Sill to back corner is not to bad but if you are anal about it you will end up cutting and dropping the front fender, which causes a whole other problem with the front wheel well. I had not noticed mine until it was brought up here and decided I could live with it.
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
