|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-31-2003, 03:02 PM
|
#1 |
|
Collector of Projects
Join Date: Apr 2003
Location: Las Vegas
Posts: 3,106
|
control arm shaft questioins?
Ok. I just got the lower control arm shafts for my 71 C10. They are Moog. They have an odd dimple drilled into one end of the shaft. I havent taken the control arms off yet so I was wondering if some one can shed some light on this. Why are they there?
On the upper arm shafts, where can I get new shims? |
|
|
|
10-31-2003, 03:20 PM
|
#2 |
|
Progress = 0%
Join Date: Nov 2001
Location: Kansas City, MO
Posts: 2,108
|
Are you referring to the holes that are about 5/8" dia and about 1/4" deep? If so, they locate the control arm shaft front-to-back. When you pull your old a-arms off, you'll see a stud sticking down in the curved area where the shaft sits. Therefore, those "holes" need to be facing the front when you install them on thea-arms.
__________________
Jason - '67 GMC swb | '57 Bel-Air 4dr hardtop | '56 210 4dr Wagon | 2000 GMC Sierra |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
