|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-26-2013, 07:43 PM
|
#1 |
|
Registered User
Join Date: Apr 2013
Location: HOUSTON
Posts: 17
|
turn over but will not start
I have an 81 c10 with a 350 and it will turn over, plus it has fuel going in, but I won't start.
Posted via Mobile Device Posted via Mobile Device |
|
|
|
05-26-2013, 08:09 PM
|
#2 |
|
Registered User
Join Date: Jul 2005
Location: CT
Posts: 278
|
Re: turn over but will not start
Did you check for spark? check the ignition system
|
|
|
|
|
05-26-2013, 08:17 PM
|
#3 |
|
Registered User
Join Date: Apr 2013
Location: GREAT FALLS, MT
Posts: 2
|
Re: turn over but will not start
F.A.S.T.
Fuel Air Spark Timing start with the basics good luck |
|
|
|
|
05-27-2013, 12:48 AM
|
#4 |
|
Registered User
Join Date: Apr 2013
Location: HOUSTON
Posts: 17
|
Re: turn over but will not start
I think I made a mistake in the wiring of the starter. Are there any cables that go from the starter to the distributor
Posted via Mobile Device |
|
|
|
|
05-27-2013, 10:59 AM
|
#5 | |
|
Registered User
 
Join Date: Apr 2009
Location: New Freedom Pa.
Posts: 1,335
|
Re: turn over but will not start
Quote:
Desert Last edited by Desert1957; 05-27-2013 at 11:04 AM. |
|
|
|
|
|
05-27-2013, 11:07 AM
|
#6 |
|
Registered User
Join Date: Apr 2009
Location: New Freedom Pa.
Posts: 1,335
|
Re: turn over but will not start
here is a pic
|
|
|
|
|
05-27-2013, 11:51 AM
|
#7 |
|
Registered User
Join Date: Apr 2013
Location: HOUSTON
Posts: 17
|
Re: turn over but will not start
Thank you very much. I kept reading that there is no wire going from the starter to distributor if its HEI? Is this true?
Posted via Mobile Device |
|
|
|
|
05-27-2013, 01:16 PM
|
#8 |
|
Junior Member
Join Date: Dec 2006
Location: Southeast Missouri
Posts: 2,436
|
Re: turn over but will not start
If it has a Hei distributor it gets its power from the ignition switch, if I remember right. On some trucks there is a 12 volt feed from the large positive post on the battery to the fuse block, but I am not sure which years.
__________________
'67 Chevy C-20 short stepper - build complete, 454/SM-465. '75 C-30 Single Cab DRW-350 small block/NP-435. '77 GMC-6500 Dump Truck, 427 Tall Deck. '92 GMC K-3500 Duallie, 454/4L80E. |
|
|
|
|
05-28-2013, 11:24 AM
|
#9 |
|
78K & 79C Jimmys
Join Date: Nov 2009
Location: Ottawa Ont CANADA
Posts: 7,901
|
Re: turn over but will not start
the HEI wire comes out of the harness,through the firewall plug
not right from the bat(needs on/off)
__________________
John 1978 GMCJimmy4X4-350/203 1979 GMCJimmy4X2-305/350 |
|
|
|
|
| Bookmarks |
| Tags |
| turnover, will not start |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
