|
08-24-2013, 05:53 AM
|
#1 |
|
Registered User
Join Date: Sep 2010
Location: Lake Havasu City Arizona
Posts: 863
|
C20 LCA On a C10
Was at wrecking yard the other day and they had some C20s and I noticed that the spring pocket in the lower control arm is quite a bit deeper than my C10 arms. Anyone else notice this? i would guess at least an inch deeper.
And the bushing is not the big rubber one. Its more compact and would be less likely to drag. So my question is will these C20 LCAs fit on my C10. Will a C10 lower ball joint fit the C20 arm? Whats with the bushings. How do you service (replace) them? Are the c20 uppers any different than the c10? I read somewhere that the shafts were thicker giving added positive camber. ? This is on a squarebody 81+ Thanks Posted via Mobile Device
__________________
|
|
|
|
08-24-2013, 11:17 AM
|
#2 | |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,068
|
Re: C20 LCA On a C10
Quote:
The different bushings are the same used pre-73 for all GM trucks. They're the standard metal sleeve w/a rubber lining. Local auto parts should still carry them (they screw onto the arm/shaft combo). The C20/30 upper shafts are thicker which would yield more positive camber vs the C10's w/the same qty of shims. But... the C10 upper shaft studs are 1/2"; the C20/30's are 9/16" so using the C20 shafts would require the larger retaining studs (& the work to make it happen).
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
|
08-24-2013, 09:37 PM
|
#3 |
|
Registered User
Join Date: Sep 2010
Location: Lake Havasu City Arizona
Posts: 863
|
Re: C20 LCA On a C10
Thanks for the info.
Do you know if the ball joint taper/size is the same? Posted via Mobile Device
__________________
|
|
|
|
|
08-25-2013, 11:25 AM
|
#4 | |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,068
|
Re: C20 LCA On a C10
Quote:
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
 |
| Bookmarks |
| Tags |
| ball joint, c10, c20, lower control arm, swap |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
