|
02-15-2014, 08:34 PM
|
#1 |
|
Registered User
Join Date: Jan 2008
Location: HOUSTON TX
Posts: 1,161
|
2 piece drive line
Beating a dead horse, but I am still not clear on this. Drop member extreme with ls motor, 4l60e trans running to carrier out to rear with stock trailing arms
Ok I know I need to set it at ride height and set trans pointing down to 6 degrees. My rear end it point down towards the carrier bearing. What I have is both shafts running down hill towards the carrier bearing. Is this correct? I know I need to get the exact angles but my drive line looks like a v from trans to diff. Any and all help would be great. |
|
|
|
02-15-2014, 10:43 PM
|
#2 |
|
Registered User
Join Date: Jan 2008
Location: Post Falls, Idaho
Posts: 606
|
Re: 2 piece drive line
6 degrees seems like alot to me? I thought it was 2 to 3 degrees, no more than 3 ?
|
|
|
|
|
02-16-2014, 01:23 PM
|
#3 |
|
Senior Member
Join Date: Dec 2003
Location: Mesa,Az
Posts: 3,981
|
Re: 2 piece drive line
Dan-
Email me and I will follow up with a phone call tomorrow. It's easier to explain in conversation rather than text. I am working on a little tutorial that should be done shortly. Nate@pbfab.com
__________________
www.PorterbuiltFabrication.com Phone: 480-297-2621 E-mail: sales@pbfab.com Find us on FaceBook under Porterbuilt Fabrication Specializing in Chassis and Suspension Components for your Classic Chevrolet Truck. We offer components from the following manufacturers: Porterbuilt Accuair Ridetech (Air Ride Technologies) Air Lift Wilwood Intro Unisteer ECE Gotta Show Air Lift Borgeson CPP Supporting this forum since 2003! |
|
|
|
|
02-16-2014, 06:27 PM
|
#4 |
|
Registered User
Join Date: Jan 2008
Location: HOUSTON TX
Posts: 1,161
|
Re: 2 piece drive line
Think I found my answer, if this diagram is correct.
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
