|
02-21-2014, 04:38 PM
|
#1 |
|
Registered User
Join Date: Dec 2012
Location: Woolwich Twp, NJ
Posts: 445
|
Heater Control Lense
Is there any place I can pick one of these bad boys up? Mine's a bit cloudy and since I am taking painstaking details on restoring things I hate to put this back in looking like this...
__________________
64 Step Side - The Mistress |
|
|
|
02-22-2014, 09:16 PM
|
#2 |
|
Registered User
Join Date: Dec 2012
Location: Woolwich Twp, NJ
Posts: 445
|
Re: Heater Control Lense
Nada?
__________________
64 Step Side - The Mistress |
|
|
|
|
02-22-2014, 09:31 PM
|
#3 |
|
Registered User
Join Date: May 2010
Location: Hillsboro, Oregon 97123
Posts: 1,300
|
Re: Heater Control Lense
How are you planning to put it back in?...I assume you ground off the rivets.. ???
__________________
Measure with a yard stick Mark with Chalk Cut with a torch  Built it yourself, don't count on others to to do it for you or with you. It will never get done |
|
|
|
|
02-22-2014, 09:56 PM
|
#4 |
|
Registered User
Join Date: Dec 2012
Location: Woolwich Twp, NJ
Posts: 445
|
Re: Heater Control Lense
I drilled out the rivets... the plan is to rivet it back in place... haven't tried the toothpaste trick - but it's not cloudy normal cloudy... the previous owner had "primed" the interior of the cab .... I suspect maybe he used chemical stripper or something in there because the surface of the plastic is literally pitted - the lense in the instrument cluster was in similar disarray... I picked up a new lense for the cluster - was just hoping someone had a line on a repop. I'll post in the WTB section...
__________________
64 Step Side - The Mistress |
|
|
|
|
02-22-2014, 10:18 PM
|
#5 |
|
Chevy addict
Join Date: May 2012
Location: Iron Ridge, WI
Posts: 1,085
|
Re: Heater Control Lense
Wet sand and buff it. Riveting may crack the edges before the rivet pops.
|
|
|
|
|
02-23-2014, 11:39 AM
|
#6 |
|
Registered User
Join Date: May 2010
Location: Hillsboro, Oregon 97123
Posts: 1,300
|
Re: Heater Control Lense
I did mine and I used a little dab of JB weld to replace it...its held now for 3 years just fine
__________________
Measure with a yard stick Mark with Chalk Cut with a torch Built it yourself, don't count on others to to do it for you or with you. It will never get done |
|
|
|
|
02-24-2014, 06:26 PM
|
#7 |
|
Registered User
Join Date: Dec 2012
Location: Woolwich Twp, NJ
Posts: 445
|
Re: Heater Control Lense
Thanks guys... JB Weld it is... I'll let you know how the rest goes...
__________________
64 Step Side - The Mistress |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
