Cab Reinstallation - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**ChevyJr** · 10-19-2014, 07:25 PM

Does anyone have a thread or photos of a cab installation gone not so well. I know the cab/bed gap will change once the new bushings are crushed, but its already sitting lower than where it should be. Has anyone had to use extra shims with the bushings? Or is it just me? Thanks for any input.

Lugnutz65 · 10-19-2014, 09:04 PM

Quote:

Originally Posted by ChevyJr

Does anyone have a thread or photos of a cab installation gone not so well. I know the cab/bed gap will change once the new bushings are crushed, but its already sitting lower than where it should be. Has anyone had to use extra shims with the bushings? Or is it just me? Thanks for any input.

I recently put my 1965 C10 cab back on the frame. How do you have your bushings installed?

Here's a link.

10-19-2014, 07:25 PM	#1
ChevyJr Junior Member Join Date: Feb 2013 Location: Minneapolis Posts: 87	Cab Reinstallation Does anyone have a thread or photos of a cab installation gone not so well. I know the cab/bed gap will change once the new bushings are crushed, but its already sitting lower than where it should be. Has anyone had to use extra shims with the bushings? Or is it just me? Thanks for any input.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.