|
04-17-2015, 11:27 PM
|
#1 |
|
Registered User
Join Date: Sep 2011
Location: McAlester Olahoma
Posts: 114
|
obd2 wiring?
ok hit a wall
pin 58 goes to pin2 on obd pin 16 gets 12v battery pin 4 Look like just a ground off the body pin 5 is a blk/wht but I don't have this wire Where would it be on the pinout? Check engine light pin 46 what ground would it be just blk or is it the blk/wht that I cant find or maybe remove in a opps.Thanks Kevin |
|
|
|
04-18-2015, 12:49 AM
|
#2 |
|
Registered User
 
Join Date: Feb 2004
Location: brownfield texas (west texas)
Posts: 1,936
|
Re: obd2 wiring?
I'm not positive, but I always thought the wire for the check engine is the computers way to provide a ground to a light wired to an open circuit. Lt1swap.com should have your answer s
__________________
The Ghost 67 short wide full custom. 550 hp LSX, 4l80E, narrowed 9". Body dropped w/air ride! ........................ ___ .........________//__{\_____ ,,,,,,,/__(⊙)___//___/__(O)_/ @disciple2.rc 💪instagram💪 LED TAILS |
|
|
|
|
04-18-2015, 12:25 PM
|
#3 |
|
Registered User
Join Date: Dec 2009
Location: Independence Mo
Posts: 4,119
|
Re: obd2 wiring?
Both the black and black/white wires in the OBD2 port are grounds. I usually hook them together and ground them at the back of the head where the rest of the engine harness is grounded. Personally, I wouldn't hook the ground to the body.
The check engine light wire coming out of the PCM is the ground side for the light, you need to hook the other side to a "key on" ignition source.
__________________
My '72 short bed build. http://www.ls1tech.com/forums/conver...6-0-4l80e.html 5.3 swap into my RUSTY '71 C10 http://ls1tech.com/forums/conversion...71-c-10-a.html |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
