|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-09-2015, 07:10 PM
|
#1 |
|
Registered User
Join Date: Jun 2008
Location: space station delta farce (justin tx)
Posts: 594
|
mustang tank vent questions
I have installed a 64-67 mustang tank in my 66 .i am to the point where I'm ready to mount my cap , I am thinking of using a late model cap mounted under a trap door in the middle of my bed. then taping into the fill neck mounting a vent tube to run up in to the bed side so I don't loose fuel from it sloshing up and out of the cap. I am just wondering if anyone has already done this or has any other ideas as to how to handle this situation.
__________________
Between saying and doing many a pair of shoes are worn out 
|
|
|
|
07-09-2015, 07:38 PM
|
#2 |
|
Registered User
 
Join Date: Jul 2007
Location: New River Arizona
Posts: 1,180
|
Re: mustang tank vent questions
You could run it up into the bedside and make a loop of steel line so water will not get in. As long as it is as high above the tank as possible I think it will be good. How did the mustang tank fit?
|
|
|
|
|
07-09-2015, 07:46 PM
|
#3 |
|
Registered User
Join Date: Jun 2008
Location: space station delta farce (justin tx)
Posts: 594
|
Re: mustang tank vent questions
Like carp will not be doing it again. you have to move rear cross member back and remove a small brace and narrow the rails then I boxed the frame. But hey it's done so the only thing I can do is move forward.
__________________
Between saying and doing many a pair of shoes are worn out
|
|
|
|
|
07-09-2015, 07:54 PM
|
#4 |
|
Registered User
Join Date: Jun 2008
Location: space station delta farce (justin tx)
Posts: 594
|
Re: mustang tank vent questions
__________________
Between saying and doing many a pair of shoes are worn out
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
