Harness Help....1st attempt!

[MercRising]

Hey y'all! Been working on a 2003 Tahoe/C-K harness to make it Standalone. I have questions about that scope outside the 2002 harness re-work on LT1Swap, because his process goes through a 2002 harness without a TAC Module. Not sure about a few wires on the trans too. Any help is appreciate, I am in way over my head on a first swap an no prior experience. I'm close, but no pals to feed beers to for hands on guidance locally!

So:
1) I have 2 Pinks on the Range Sensor, pins C - Ign 1, and E - Starter Relay. Do I need both?

2)Looks ok to remove the LtGrn-ParkNPark, DkGrn-ParkNStart, and Gray-Trailer Brake Lights from the Range Sensor plug. Is that correct?

3) Do I need both Pinks on the Trans Plug, E-Fuse Output Run Crank, and N-Trans Pressure Switch Signal

4) It looks safe to remove the LightBlu- CHM Stop Lamp voltage from the TAC connector plug too. Is that correct?

[ls1nova71]

1 and 2, if you're not using the range sensor for back up lights or as a neutral safety switch then you don't need them. 3 Dont remove any wires from the trans plug! And 4, you need to hook up to the brake switch, the wire that is hot when brakes are applied.

[MercRising]

Thanks, looks like your threads on LS1Tech will help me out too!!

[BR3W CITY]

Not sure if it helps, but I don't even have that range sensor wiring in my harness, at all. The harness was built without it, but it doesn't contain "need to run" functions, just so were clear.