|
03-19-2004, 01:29 PM
|
#1 |
|
Registered User
Join Date: Apr 2003
Location: Lubbock, Texas
Posts: 248
|
Van Tilt Installation
Purchased a van tilt from one of our board members, ROD. Thanks ROD for the fast shipment.
Anyways, now I'm trying to get it installed. Is there a good way to remove the rubbers and flange that bolts to the firewall and reinstall on the new tilt? I have seen some discussions regarding this installation, but they never address the rubber installation. I saw an article which showed bending the shifter arm down to let the rubbers slide over, but I'm a little worried that I'll just end up buggering up the unit. I could cutt off the arm, and then reweld after installation of the rubbers. Is there a better way? Rick |
|
|
|
03-19-2004, 04:09 PM
|
#2 |
|
Senior Member
 
Join Date: Apr 2000
Location: madison indiana
Posts: 3,836
|
i always bend the arm down then,make sure all the rubber is on correctly then bend it back straight.
if you break it THEN weld it back on.. good luck jamie
__________________
jamie72 72 BB cheyenne -- Restoration getting started.. member #807 http://www.myspace.com/whitetailobsession www.antlertalk.com |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
