Steering column/shaft issue - Guidance Needed

[51Chevy3100]

Hey guys, I have an issue with my steering on my 1987 Chevy V30 4x4. I switched from the rag joint style to the u joint style shaft (jeep conversion) awhile back. I recently took my body lift off so I took the shaft out because I couldn't get it to adjust to the new ride height.

I know I need to get it moving and have a plan for that but my concern is that the "D" part on the intermediate shaft (I believe that's what it is) where it goes into the column thru the firewall moves in and out and I know it should stay in place. What do I need to replace to get it right? Bearing?

This picture is not of mine, just a reference of what I'm talking about. My truck doesn't have the part that the retainer clip goes thru or anything...the shaft just goes in the column and has side to side and in and out play.

[Pontiac1976]

Bearing lower may going. shaft may be loose. broken parts in side.
It maybe time to take the steering wheel off check what going on in it.
http://bowtieguy.proboards.com/threa...r-repair-renew

this may help

[51Chevy3100]

Originally Posted by Pontiac1976

Bearing lower may going. shaft may be loose. broken parts in side.
It maybe time to take the steering wheel off check what going on in it.
http://bowtieguy.proboards.com/threa...r-repair-renew

this may help

Thanks for the reply! I robbed some parts from another steering column. Turns out my lower bearing and plastic retainer were completely gone. I just didn't know what was missing because I didn't know what was supposed to be there. Always learning something!