Engine height and output shaft angle

[shifty]

Originally Posted by 62chevy302

I finally got my engine set back down into the frame. My engine angle is at 3 degrees as it sets now. Im afraid that when I add the rest of my front end sheetmetal, wiring, interior it will be below 1 degree. I realized that my original problem was that the springs were too stiff and my suspension was sprung all the way up.

I was literally just wondering about this and figured I'd check the forum rather than PM.

Is this with the new mounts or the old mounts? If the new mounts, is it possible to adjust things to a different mount point and get the angle you want?