|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-05-2019, 06:09 PM
|
#1 |
|
Registered User
Join Date: Oct 2011
Location: bartlesville ok
Posts: 143
|
swap harness pin question
hey all,
just a question about the vss wires on green connector pins 20 and 21. which wire would a person connect to a Dakota digital 128,000 pulse generator? sen-01-128 instructions have three wires red(power for the sensor) black(ground) and white which speed input to pcm. which wire does it go to, pin 20 is low signal and pin 21 is high signal according to the pinout from lt1swap. thanks for any input. Chip |
|
|
|
07-05-2019, 07:52 PM
|
#2 |
|
Registered User
Join Date: Dec 2009
Location: Independence Mo
Posts: 4,119
|
Re: swap harness pin question
I dont think high and low make any difference in a VSS signal. The low is a ground signal and high is the sensor signal so I would go with the high.
__________________
My '72 short bed build. http://www.ls1tech.com/forums/conver...6-0-4l80e.html 5.3 swap into my RUSTY '71 C10 http://ls1tech.com/forums/conversion...71-c-10-a.html |
|
|
|
|
07-05-2019, 08:27 PM
|
#3 |
|
Registered User
Join Date: Oct 2011
Location: bartlesville ok
Posts: 143
|
Re: swap harness pin question
Thank you for the info nova!
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
