2 bbl Rochester Carb help

[65ChevyC20]

I recently acquired a Rochester 2 bbl manual choke carb for my ‘65. It was in pieces when I got it but I dipped it in carb clean, installed a rebuild kit but for the life of me I can’t figure out the linkage. I have two rods left and a cam to install. I don’t have the old carb so I wasn’t able to match it up. Does anyone run a manual choke on their truck? Could you click a few pics and post them so I can get my carb assembled.
I scoured the ‘net looking for some detailed pics but really didn’t find anything beneficial.

This is where I’m at
Posted via Mobile Device

PS, i couldn't get my picture to post.

[65ChevyC20]

Originally Posted by 65ChevyC20

I recently acquired a Rochester 2 bbl manual choke carb for my ‘65. It was in pieces when I got it but I dipped it in carb clean, installed a rebuild kit but for the life of me I can’t figure out the linkage. I have two rods left and a cam to install. I don’t have the old carb so I wasn’t able to match it up. Does anyone run a manual choke on their truck? Could you click a few pics and post them so I can get my carb assembled.
I scoured the ‘net looking for some detailed pics but really didn’t find anything beneficial.

This is where I’m at
Posted via Mobile Device

Posted via Mobile Device

[bsarts]

I'm away from home for a while , but I have this pic if it helps.

[65ChevyC20]

I see the one rod but don't see the other. If you could click a few pics when youre able it would be appreciated. Thanks for the quick response!

[geezer#99]

The two link rods are for the accelerator pump and high idle cam.
Lots of info here and a nice carb components break down pic at the end.



https://c777913.ssl.cf2.rackcdn.com/...2gc_manual.pdf