near rear window - The 1947 - Present Chevrolet & GMC Truck Message Board Network

alpha_male0203 · 09-08-2004, 11:03 PM

how do i put it in. its a sliding one. if that helps. thanks shane

Greenlee · 09-09-2004, 12:25 PM

You just push the old glass out.Carefully.

Most sliders utilize the OEM gasket.It wouldn't hurt to track down a new one if you can,makes it easier to install too.

To install,you need to run a small thin rope around the weatherstrip channel.Then start the bottom edge onto the body,and use the rope (pulling) to feed the rest of the gasket into place.Leaving the gasket out in the sun (or use hot water),and lots of soapy water will ease installation.

09-08-2004, 11:03 PM	#1
alpha_male0203 95 extended cab sportside Join Date: Jul 2004 Location: Clinton, Iowa western. Posts: 895	near rear window how do i put it in. its a sliding one. if that helps. thanks shane __________________ 95 Chevy k 1500 00 Chevy Silverado 1500 07 cobalt Old ladies car]

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

09-09-2004, 12:25 PM	#2
Greenlee Registered User Join Date: Jun 2004 Location: El Lago, TX Posts: 1,668	You just push the old glass out.Carefully. Most sliders utilize the OEM gasket.It wouldn't hurt to track down a new one if you can,makes it easier to install too. To install,you need to run a small thin rope around the weatherstrip channel.Then start the bottom edge onto the body,and use the rope (pulling) to feed the rest of the gasket into place.Leaving the gasket out in the sun (or use hot water),and lots of soapy water will ease installation.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.