up and down slop in front CV joint. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

ssls6 · 02-04-2005, 08:00 PM

How much up & down slop should be in the front CV joint on a 72 K5? I don't feel any torsional slop only up and down type motion. If I rotate it by hand, the slop runs up the side and then falls down. This repeats every rotation.

Thanks,
Richard

ssls6 · 02-04-2005, 09:30 PM

Thanks. I went and checked it again and the ujoints or the center ball is out. The guy I bought it from must have filled them with grease when I picked it up.

My CV joint attaches to the TF case with 4 bolts into a flange. The H member says Spicer. Do I have a Saginaw or a Spicer CV shaft?

Regards,
Richard

ssls6 · 02-05-2005, 01:29 AM

If the pin is broke, do I need a new front driveshaft?

Thanks,
Richard

02-04-2005, 08:00 PM	#1
ssls6 Registered User Join Date: Jan 2005 Posts: 21	up and down slop in front CV joint. How much up & down slop should be in the front CV joint on a 72 K5? I don't feel any torsional slop only up and down type motion. If I rotate it by hand, the slop runs up the side and then falls down. This repeats every rotation. Thanks, Richard

02-04-2005, 09:30 PM	#2
ssls6 Registered User Join Date: Jan 2005 Posts: 21	Thanks. I went and checked it again and the ujoints or the center ball is out. The guy I bought it from must have filled them with grease when I picked it up. My CV joint attaches to the TF case with 4 bolts into a flange. The H member says Spicer. Do I have a Saginaw or a Spicer CV shaft? Regards, Richard Last edited by ssls6; 02-05-2005 at 01:24 AM.

02-05-2005, 01:29 AM	#3
ssls6 Registered User Join Date: Jan 2005 Posts: 21	If the pin is broke, do I need a new front driveshaft? Thanks, Richard



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.