|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-10-2006, 07:22 PM
|
#26 |
|
The LuvShack Garage
Join Date: Jan 2004
Location: Maple Grove, TN (West Side)
Posts: 30,468
|
Re: Surfer Rack Makeover Thread
Alloy used is 4026 for the short ones, & 6262 for the long ones due to a
minor screw up on my part drilling all the holes & the Dia. is .750 rnd sms, short rods are 41.75" long, long are 62.75" long, 1st holes are 6.25" if you measure forward from the rear ends, and then the holes are 50.5" center to center, the screws are metric 10 x 32 and 1.25" long, I used stainless allen head screws as pictured above instead of the traditional Phillips 
__________________
Owner/Op: "TN Classic Transport Carriers" The Toy: "Square Vette" 72 Hybrid Blazer Toy Barn: "LuvShack" 40 x 60 x 20 Shop Tow Piggy:"Maddy" 88 Silverado 3500 Hauler: "Feathers" 14 Aluma 8218T |
|
|
|
11-10-2006, 07:53 PM
|
#27 |
|
C10 Club Tennessee
Join Date: Mar 2003
Location: White House, TN 37188
Posts: 8,281
|
Re: Surfer Rack Makeover Thread
Looks good
__________________
Bryan www.gmtruckshow.com Project "Andes"-Halen's First Truck Project: Patina Burb for he is God’s servant for your good. But if you do wrong, be afraid, for he does not bear the sword in vain. For he is the servant of God, an avenger who carries out God’s wrath on the wrongdoer. Romans 13:4 |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
