|
06-14-2008, 08:34 PM
|
#1 |
|
Registered User
Join Date: Aug 2006
Location: Houston, TX
Posts: 98
|
rear end height
I am ready to install my 4-link setup and was wondering was the minumum distance from the rear end to frame before needing a c-notch? Also anyone using a driveshaft loop. How far from the ground is the loop?
|
|
|
|
06-15-2008, 07:31 AM
|
#2 |
|
Registered User
Join Date: Nov 2007
Location: Baltimore, Ohio
Posts: 65
|
Re: rear end height
I'd say that you need to find out what the coil-overs measure bottomed out and what ride height is. If bottomed out is 10" and ride height is 14", then you need 4" for the stroke plus 1" for extra added saftey.
|
|
|
|
|
06-16-2008, 06:21 PM
|
#3 |
|
Registered User
Join Date: Aug 2006
Location: Houston, TX
Posts: 98
|
Re: rear end height
Can anyone post how far the top of their rear end tubes are to the frame at ride height on a four link setup for comparision. Thanks, Ronnie
|
|
|
|
|
06-16-2008, 07:01 PM
|
#4 |
|
*---------------*
 
Join Date: Mar 2008
Location: Central Missouri
Posts: 1,791
|
Re: rear end height
Ride heights vary. Wheel and tire size vary. What truck you got?
When I get to building mine (56panel)the ride height will be around 5" so my tubes are going to be in the upper part of the frame. here's a drawing of the setup i'm working on.  You need to figure out your ride height and tire height.
__________________
2001 GMC SIERRA 1956 Chevy Panel Build Page with a Scott's Hotrods IFS 1953 Chevy trucks Project Dime Time 1968 Camaro 1968 Volksrod "NOBACK" Jared Last edited by GRIMSS; 06-16-2008 at 07:02 PM. |
|
|
|
 |
| Bookmarks |
|
|
55-59 one piece window 
Linear Mode
