|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-19-2009, 10:32 PM
|
#1 |
|
Registered User
Join Date: Jan 2008
Location: Oakdale, Ca
Posts: 655
|
Question about air ride tech gauge
I am wanting to run air ride technologies level pro system with the digital gauge that controls all 4 corners. My question is does anybody know the dimensions of the gauge? I want to run the attached gauge cluster that will contain auto meter gauges, and I would like to remove the center gauge and replace it with the air ride digital gauge. I am not sure if there is enough room in between the 2 large gauges to cut into the panel and place the air ride gauge. I dont want to invest $230 in a gauge panel to find out it wont fit. I am sure the distance between the 2 large gauges is similar to stock since this unit was made to resemble the stock gauges. If any Air Ride Tech members can provide input i would appreciate it, hope I explained it well enough.
__________________
1970 2wd short/fleet 350/350 Project "iced green dream" http://67-72chevytrucks.com/vboard/s...d.php?t=272702 2006 Toyota Tacoma double cab 4x4 |
|
|
|
03-20-2009, 10:45 AM
|
#2 |
|
Senior Member
Join Date: Aug 2002
Location: Plymouth, MA
Posts: 891
|
Re: Question about air ride tech gauge
They used to have a dimensions page on their website. I haven't been able to find it, but I am sure it is there somewhere.
__________________
1972 Blazer body...need to get a thread started for the rest of the story |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
